How to debug a lost connection problem?

["Larry W. Virden" <lvirden@xxxxxxx>]

Anyone have any ideas on how to debug the following situation?
When I sync or backup my Palm Pilot III PalmOS 3.0.2 using PilotManager 1.107,
I first get a warning

Rate 115200 too high, dropping to 57600
and then get an error on the Pilot saying 
The connection between your Palm III and the desktop was lost.
Some of your data was NOT backed up.   Please check your setup
and try again.

It doesn't matter whether I do the sync/backup first or last.  What does
happen is that if I do it last, all the rest of the syncs occur fine.

Is there anything peculiar about the SyncMemo that would cause this
behavior?  There's nothing in the hotsync.log on either side to convey
why the connection is considered lost.

 
-- 
Larry W. Virden                 <URL: mailto:lvirden@xxxxxxx>
<URL: http://www.purl.org/NET/lvirden/> <*> O- "No one is what he seems."
Unless explicitly stated to the contrary, nothing in this posting should 
be construed as representing my employer's opinions.
-><-
------------------------------------------------------------------------
***********************************************************
*             This is a public mailing list!              *
* Please do not publish Sun proprietary information here! *
*        -  -  -  -  -  -  -  -  -  -  -  -  -  -         *
*             http://www.moshpit.org/pilotmgr             *
***********************************************************